Skip to content
Boiler Protection Plan

Keep your hydronic heating safe, efficient, and reliable with our Boiler Protection Plan. This membership bundles an annual tune-up, combustion/safety testing, priority scheduling, and member-only repair discounts for modulating condensing (mod-con), combi, and cast-iron boilers across the Greater Toronto Area (GTA).

Boiler Protection Plan

Keep your hydronic heating safe, efficient, and reliable with our Boiler Protection Plan. This membership bundles an annual tune-up, combustion/safety testing, priority scheduling, and member-only repair discounts for modulating condensing (mod-con), combi, and cast-iron boilers across the Greater Toronto Area (GTA).

Quick Highlights

  • Annual tune-up & combustion analysis (O₂/CO/CO₂) by licensed gas-fitters

  • Safety checks: CO/venting review, pressure relief valve, expansion tank, and low-water cutoff (where equipped)

  • Hydronic performance: purge/bleed air, verify ΔT, balance zones, test ECM/PSC circulators & zone valves

  • Condensing care: flue inspection, condensate trap & neutralizer service

  • Combi/indirect DHW checks: plate HX descaling (as needed), diverter/3-way valve, DHW sensors

  • Priority scheduling and member-only repair discounts with up-front pricing


What’s Included in Your Plan

Safety & Compliance

  • Full combustion analysis and draft verification

  • Gas train tests: leak check, inlet/manifold pressure, regulator operation

  • Venting inspection (direct/concentric, chimney liner/power-vent), terminations & clearances

  • Relief valve test, expansion tank pre-charge verification, backflow/PRV inspection

  • Low-water cutoff/limits and safeties check (where installed)

Hydronic Performance

  • System purge/bleed and air removal device service (air/dirt/mag separator)

  • Circulator amp draw & speed check (ECM/PSC), zone valve operation, differential/balancing review

  • Measure supply/return temps and verify design ΔT (~20°F / 11°C)

  • Outdoor reset curve review & tuning (mod-cons) for smoother comfort and lower fuel use

Mod-Con & Condensate Care

  • Primary heat-exchanger inspection/cleaning (as accessible)

  • Condensate trap clean, neutralizer media check/replacement recommendation

  • Vent gaskets and condensate routing/slope verification

DHW (Combi & Indirect)

  • Plate heat-exchanger descaling (as needed), diverter/3-way valve test

  • DHW sensor/NTC sanity checks and priority control verification (indirect tanks)

  • Recirculation pump/control check where present

Reliability & Documentation

  • Tighten electrical connections, inspect controls/boards and wiring

  • Two full heat cycles; noise/vibration assessment

  • Written maintenance report with baseline readings and recommendations

Quick Highlights

  • Annual tune-up & combustion analysis (O₂/CO/CO₂) by licensed gas-fitters

  • Safety checks: CO/venting review, pressure relief valve, expansion tank, and low-water cutoff (where equipped)

  • Hydronic performance: purge/bleed air, verify ΔT, balance zones, test ECM/PSC circulators & zone valves

  • Condensing care: flue inspection, condensate trap & neutralizer service

  • Combi/indirect DHW checks: plate HX descaling (as needed), diverter/3-way valve, DHW sensors

  • Priority scheduling and member-only repair discounts with up-front pricing


What’s Included in Your Plan

Safety & Compliance

  • Full combustion analysis and draft verification

  • Gas train tests: leak check, inlet/manifold pressure, regulator operation

  • Venting inspection (direct/concentric, chimney liner/power-vent), terminations & clearances

  • Relief valve test, expansion tank pre-charge verification, backflow/PRV inspection

  • Low-water cutoff/limits and safeties check (where installed)

Hydronic Performance

  • System purge/bleed and air removal device service (air/dirt/mag separator)

  • Circulator amp draw & speed check (ECM/PSC), zone valve operation, differential/balancing review

  • Measure supply/return temps and verify design ΔT (~20°F / 11°C)

  • Outdoor reset curve review & tuning (mod-cons) for smoother comfort and lower fuel use

Mod-Con & Condensate Care

  • Primary heat-exchanger inspection/cleaning (as accessible)

  • Condensate trap clean, neutralizer media check/replacement recommendation

  • Vent gaskets and condensate routing/slope verification

DHW (Combi & Indirect)

  • Plate heat-exchanger descaling (as needed), diverter/3-way valve test

  • DHW sensor/NTC sanity checks and priority control verification (indirect tanks)

  • Recirculation pump/control check where present

Reliability & Documentation

  • Tighten electrical connections, inspect controls/boards and wiring

  • Two full heat cycles; noise/vibration assessment

  • Written maintenance report with baseline readings and recommendations

  • Priority service during cold snaps

  • Member-only repair discounts on parts & labour

  • Reduced diagnostic fees on service calls

  • Transferable to the next homeowner at the same address

  • Bundle savings when you add Furnace, AC, Heat Pump, or Water Heater plans

  • Essential – Annual boiler tune-up & combustion analysis, safety checks (relief/expansion/LWCO), hydronic purge/ΔT verification, vent/condensate inspection, priority scheduling, member discounts

  • Enhanced – Everything in Essential plus heat-exchanger cleaning (as accessible), air/dirt/mag separator service, and outdoor reset optimization

  • Premium – Everything in Enhanced plus plate HX descaling (combi) or indirect tank inspection, neutralizer media replacement, mid-season check, and highest-priority queuing

(We’ll help you pick the right tier for your boiler type and water quality.)

Homeowners, landlords, and light-commercial sites that want fewer breakdowns, lower fuel bills, safer operation, and documented maintenance that supports manufacturer warranty requirements.

  • Pre-existing failures, concealed code violations, inaccessible equipment

  • Major repairs/parts or piping/radiator replacements not listed (member discounts apply)

  • Full system flushes, glycol changes, or inhibitor dosing (available upon request)

  • Chimney liner replacement, extensive vent rerouting, or gas/electrical upgrades beyond inspection

Proudly serving the Greater Toronto Area (GTA) and surrounding communities. Contact us to confirm availability in your neighborhood.

Do you service all boiler types?
Yes—mod-con, combi, and cast-iron boilers, plus hydronic baseboard, radiators, and radiant floors.

Will this help keep my warranty valid?
We perform manufacturer-style maintenance and provide service records, which many warranties require. Check your policy for specifics.

Do you balance zones and verify pumps?
Yes—we check circulator performance, zone valve operation, ΔT, and balance for quiet, even heat.

What about water quality and magnetite?
We service air/dirt/mag separators and can recommend inhibitor or filtration options if magnetite/scale is present.

Is plate HX descaling included for combi units?
Included at Premium, available as an add-on at other tiers.

How often should I service my boiler?
Annually. Mod-cons especially benefit from yearly combustion analysis, HX cleaning, and condensate service.

Keep it running like new

Choose our All Service Plans for annual tune-ups, priority service, repair discounts, and system-specific safety checks across your furnace, air conditioner, heat pump, water heater/tankless, and boiler—including CO/combustion, refrigerant/condensate, and T&P/expansion-tank verifications. Preventive maintenance extends equipment life, improves efficiency, and keeps your home safe and comfortable year-round.

 

Ready for quieter, more efficient heat? Book your free in-home quote today.

At Coffee Heating and Air Conditioning, we proudly offer a full spectrum of residential and commercial HVAC services across Toronto and the Greater Toronto Area. From expert installation of high-efficiency furnaces, air conditioners, boilers, and water heaters to precision repairs, emergency service calls, and routine system maintenance, our certified technicians ensure year-round comfort and safety for every client. We also specialize in air quality improvements, duct cleaning, smart thermostat integration, and energy-saving upgrades tailored to your home or business. Whether you’re building new, upgrading, or need fast repairs, our team delivers responsive, reliable solutions backed by industry expertise and a commitment to excellence.

At Coffee Heating and Air Conditioning, we proudly offer a full spectrum of residential and commercial HVAC services across Toronto and the Greater Toronto Area. From expert installation of high-efficiency furnaces, air conditioners, boilers, and water heaters to precision repairs, emergency service calls, and routine system maintenance, our certified technicians ensure year-round comfort and safety for every client. We also specialize in air quality improvements, duct cleaning, smart thermostat integration, and energy-saving upgrades tailored to your home or business. Whether you’re building new, upgrading, or need fast repairs, our team delivers responsive, reliable solutions backed by industry expertise and a commitment to excellence.

Back To Top
Call Now Button